Tag: fencing company des moines

The Wooden Fence Installers

The installation of a wooden fencing is not a difficult task. You can build a fence with a bit of effort, household tools, and enough knowledge. In this article, we will outline the steps for installing wooden fencing. To get started, here is a checklist of all the necessary tools. Make sure that you have the necessary integrity fencing company on hand to finish the project.

The Tool List

Boards & Posts

Power Saw

Post Hole Digger

Paint or Outdoor Stain

Steel Tape

Marking Pencil

Small Axes or Hatches

Gravel and Sand


Hand Saw


Work Gloves

You can also find out more about Level

Ready-Mix Concrete

Wood Chisel

Tamping rod

Wood Preservative

Plumb bob

There are many other options depending on your preferred style. It is possible to also use a tractor, small cement mixer, post hole digger or power tool to dig holes, level the area and transport the materials. You should call an experienced fence company if at any stage you start to feel uneasy. You want to make sure that the fence you install is done right. It is important that the posts are tall enough for them to reach their desired height even if they’re buried 24-30″.

First step: rough survey

Find the boundary pins, and then lay out the fence with the string. You must then determine the post locations once you have set the boundaries. Starting at the corners and placing posts between six and eight feet (measured by the center of each post), start the installation. The next step is to determine how large and where you want the gates or obstacles.

The second step is to install the posts

Start at the end if this is your very first fence. Small imperfections will be easier to conceal when you are farther away. Examine the locations of the posts and look for anything that might impede or damage construction equipment. It’s time to dig postholes. Do not dig holes until the work is complete. Otherwise, the water will overflow or they may collapse. Also, it is important that the hole be as close to vertical as you can. The concrete should be carefully mixed following the instructions of the manufacturer. To brace your post, use some scraps of wood. You will need to center your entire line at corners and first posts. Pour 2 to 3 inches of gravel at the bottom to ensure drainage. This also prevents the post rotting. The post should be placed carefully in the hole to avoid causing the sides to collapse. Attach the two braces at opposite ends and the plumb bob to the top of your post, so that it hangs freely. It is important that the post be square and braced solidly on three axes before pouring the concrete. Confirm that the concrete still holds the post in position and then dig the next one. It is important to create a mound of concrete so water can drain away from your post. Overnight, allow the concrete to harden.

Attaching rails to slats

Remove the bracing once the concrete has set and make sure that the post’s position is correct. Start at the corner, preferably in the front, and attach rails using screws, dowels, nails, metal brackets, etc. To ensure that nothing is out of alignment, check frequently to make sure the rails are level and the post positions in the right place. To prevent decay and moisture, leave a 2-inch gap between the rails.